Li Chunying, Wu Xiaodong. Numerical Simulation of Remaining Oil Distribution in Cyclothem[J]. Petroleum Drilling Techniques, 2012, 40(1): 88-91. DOI: 10.3969/j.issn.1001-0890.2012.01.018
Citation: Li Chunying, Wu Xiaodong. Numerical Simulation of Remaining Oil Distribution in Cyclothem[J]. Petroleum Drilling Techniques, 2012, 40(1): 88-91. DOI: 10.3969/j.issn.1001-0890.2012.01.018

Numerical Simulation of Remaining Oil Distribution in Cyclothem

More Information
  • Received Date: September 07, 2010
  • Revised Date: November 11, 2011
  • The remaining oil distribution in cyclothem is playing more and more important role in the later period of oilfield development,so it is very important to study the remaining oil distribution in cyclothem for the later development adjustment of the high water-cut reservoirs using the fine numerical reservoir simulation.Conceptual models have been built on the basis of geological condition of 8th sand set of Sheng II Block in Shengtuo Oilfield to analyze the distribution rule of remaining oil in the same cyclothem.The results show that,when water flooding is calculated till the high water-cut period,vertically,remaining oil saturation of upper layers is high and that of lower layers is low and close to irreducible oil saturation in the same cyclothem.Furthermore,the smaller the layer thickness,the bigger the density difference between oil and water,and the smaller the oil viscosity,the more obvious this trend will be.But the location of perforation in injection wells has little effect on the remaining oil distribution.So the upper layers in cyclothem should be the target for later development adjustment in high water-cut period of Shengtuo Oilfield.
  • [1]
    韩大匡.准确预测剩余油相对富集区 提高油田注水采收率研究[J].石油学报,2007,28(2):73-78.Han Dakuang.Precisely predicting abundant remaining oil and improving the secondary recovery of mature oilfields[J].Acta Petrolei Sinica,2007,28(2):73-78.
    [2]
    陈霆.非均质储层模型微观水驱油实验[J].油气地质与采收率,2007,14(4):72-75.Chen Ting.Experimental study of water-oil displacement with microscopic models of heterogeneous reservoirs[J].Petroleum Geology and Recovery Efficiency,2007,14(4):72-75.
    [3]
    苏娜,黄健全,韩国辉,等.微观水驱油实验及剩余油形成机理研究[J].断块油气田,2007,14(6):50-51.Su Na,Huang Jianquan,Han Guohui,et al.Microscopic waterflood test and study on remaining oil forming mechanism[J].Fault-Block Oil Gas Field,2007,14(6):50-51.
    [4]
    王玉斗,李茂辉,温科扬.泡沫渗流机理及渗流模型研究[J].石油钻探技术,2010,38(4):104-107.Wang Yudou,Li Maohui,Wen Keyang.Study on mechanism and modeling of foam flow in porous media[J].Petroleum Drilling Techniques,2010,38(4):104-107.
    [5]
    李洪玺,刘全稳,何家雄,等.物理模拟研究剩余油微观分布[J].新疆石油地质,2006,27(3):351-353.Li Hongxi,Liu Quanwen,He Jiaxiong,et al.A study on microdistribution of residual oil by physical simulation process[J].Xinjiang Petroleum Geology,2006,27(3):351-353.
    [6]
    杜庆军,陈月明,侯键,等.胜坨油田厚油层内夹层分布对剩余油的控制作用[J].石油天然气学报,2006,28(4):111-114.Du Qingjun,Chen Yueming,Hou Jian,et al.Control of interlayer on the distribution of remaining oil in thick reservoirs of Shengtuo Oilfield[J].Journal of Oil and Gas Technology,2006,28(4):111-114.
    [7]
    胡丹丹,唐玮,常毓文,等.厚油层层内夹层对剩余油的影响研究[J].特种油气藏,2009,16(3):49-52.Hu Dandan,Tang Wei,Chang Yuwen,et al.Study on the influence of intercalation on remaining oil distribution in thick reservoirs[J].Special Oil Gas Reservoirs,2009,16(3):49-52.
    [8]
    束青林.正韵律厚油层剩余油分布模式及水平井挖潜:以孤岛油田中一区Ng5-3层为例[J].油气地质与采收率,2004,11(6):34-38.Shu Qinglin.Distribution mode of remaining oil and tapping the potential by horizontal wells in thick positive-rhythm oil layers:taking Ng5-3 layer in Zhong 1 Area of Gudao Oilfield[J].Petroleum Geology and Recovery Efficiency,2004,11(6):34-38.
    [9]
    赵红兵.三角洲前缘韵律层特高含水期剩余油分布及调整[J].特种油气藏,2006,13(2):58-63.Zhao Hongbing.Residual oil distribution and reconciliation for delta front rhythm zone in extra high water cut stage[J].Special Oil Gas Reservoirs,2006,13(2):58-63.
    [10]
    刘均荣,冯其红,韩松.浅层正韵律厚油层高含水期挖潜方法探讨[J].石油天然气学报,2007,29(3):128-130.Liu Junrong,Feng Qihong,Han Song.Method for tapping the potential for positive rhythm thick reservoirs at high water-cut stage[J].Journal of Oil and Gas Technology,2007,29(3):128-130.
    [11]
    孙梦茹.胜坨油田精细地质研究[M].北京:中国石化出版社,2004:158-170.Sun Mengru.Finely geological research of Shengtuo Oilfield[M].Beijing:China Petrochemical Press,2004:158-170.
    [12]
    魏兆亮,黄尚军.高含水期油藏数值模拟技术和方法[J].西南石油大学学报:自然科学版,2008,30(1):103-105.Wei Zhaoliang,Huang Shangjun.Reservoir numerical simulation technology and methods in high water cut period[J].Journal of Southwest Petroleum University:Science Technology Edition,2008,30(1):103-105.
    [13]
    郑浩,马春华,姜振海.高含水后期"低效、无效循环"形成条件的数值模拟研究[J].石油钻探技术,2007,35(4):80-83.Zheng Hao,Ma Chunhua,Jiang Zhenhai.Numerical simulation of the forming conditions of low and useless circling with high water cut reservoir[J].Petroleum Drilling Techniques,2007,35(4):80-83.
    [14]
    盖玉国.喇嘛甸油田特高含水期开发潜力分析[J].大庆石油学院学报,2009,33(1):105-108.Gai Yuguo.Analysis of the development potential in Lamadian Oilfield with ultra-high watercut[J].Journal of Daqing Petroleum Institute,2009,33(1):105-108.
    [15]
    冯明生,袁士义,许安著,等.高含水期剩余油分布数值模拟的平面网格划分[J].油气地质与采收率,2008,15(4):81-83.Feng Mingsheng,Yuan Shiyi,Xu Anzhu,et al.Planar grid division of the numerical simulation of remaining oil distribution during high water-cut period[J].Petroleum Geology and Recovery Efficiency,2008,15(4):81-83.
    [16]
    周炜,唐仲华,温静,等.应用数值模拟技术研究剩余油分布规律[J].断块油气田,2010,17(3):325-329.Zhou Wei,Tang Zhonghua,Wen Jing,et al.Study on distribution law of remaining oil by using reservoir numerical simulation technology[J].Fault-Block Oil Gas Field,2010,17(3):325-329.
    [17]
    李淑霞,谷建伟.油藏数值模拟基础[M].东营:中国石油大学出版社,2009:211-226.Li Shuxia,Gu Jianwei.Fundamental of reservoir numerical simulation[M].Dongying:China University of Petroleum Press,2009:211-226.
  • Related Articles

    [1]CUI Zhuang, HOU Bing. A Numerical Simulation for Damage Mechanical Behavior of Brazilian Splitting Test of Deep Shales[J]. Petroleum Drilling Techniques, 2024, 52(2): 218-228. DOI: 10.11911/syztjs.2024032
    [2]XIAN Yuxi, CHEN Chaofeng, FENG Meng, HAO Youzhi. Numerical Simulation of Multiphase Flow in Fracture Networks in Shale Oil Reservoir[J]. Petroleum Drilling Techniques, 2021, 49(5): 94-100. DOI: 10.11911/syztjs.2021090
    [3]JIA Yiyong, LI Yongkang. Techniques of Layering Injection and the Measurement-Adjustment towards Wells with Casing Damage in Shengtuo Oilfield[J]. Petroleum Drilling Techniques, 2021, 49(2): 107-112. DOI: 10.11911/syztjs.2020137
    [4]YANG Yingtao, WEN Qingzhi, DUAN Xiaofei, WANG Shuting, WANG Feng. Numerical Simulation for Flow Conductivity in Channeling Fractures[J]. Petroleum Drilling Techniques, 2016, 44(6): 104-110. DOI: 10.11911/syztjs.201606018
    [5]Chen Xiuping, Zou Deyong, Li Dongjie, Lou Erbiao. Numerical Simulation Study on the Anti-Balling Performance of PDC Drill Bits[J]. Petroleum Drilling Techniques, 2015, 43(6): 108-113. DOI: 10.11911/syztjs.201506020
    [6]Wei Xuemei. Numerical Simulation of Steam Huff-and-Puff Assisted Catalytic Aquathermolysis on Heavy Oil[J]. Petroleum Drilling Techniques, 2015, 43(3): 103-108. DOI: 10.11911/syztjs.201503019
    [7]Nie Xiangrong, Yang Shenglai. Numerical Simulation of Cooling Damage to High Pour-Point Oil Reservoirs[J]. Petroleum Drilling Techniques, 2014, 42(1): 100-104. DOI: 10.3969/j.issn.1001-0890.2014.01.020
    [8]Zhao Xinxin, Wu Xuefeng, Gao Yonghai, Li Hao, Guo Yanli. Numerical Simulation of Temperature Distribution of Blowout Preventers in Deepwater Drilling[J]. Petroleum Drilling Techniques, 2013, 41(3): 46-50. DOI: 10.3969/j.issn.1001-0890.2013.03.009
    [9]Xu Peng, Liu Xinyun, Shi Libao. Numerical Simulation for the Effect of Ground Stress on Explosive Fracturing[J]. Petroleum Drilling Techniques, 2013, 41(1): 65-69. DOI: 10.3969/j.issn.1001-0890.2013.01.013
    [10]Li Hongqian. Numerical Simulation on the Annular Flow Induced by Spiral Casing Centralizer[J]. Petroleum Drilling Techniques, 2012, 40(2): 25-29. DOI: 10.3969/j.issn.1001-0890.2012.02.005

Catalog

    Article Metrics

    Article views (2841) PDF downloads (3293) Cited by()
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return