罗宇维, 朱江林, 李东, 方国伟, 凌伟汉. 温度和压力对井内流体密度的影响[J]. 石油钻探技术, 2012, 40(2): 30-34. DOI: 10.3969/j.issn.1001-0890.2012.02.006
引用本文: 罗宇维, 朱江林, 李东, 方国伟, 凌伟汉. 温度和压力对井内流体密度的影响[J]. 石油钻探技术, 2012, 40(2): 30-34. DOI: 10.3969/j.issn.1001-0890.2012.02.006
Luo Yuwei, Zhu Jianglin, Li Dong, Fang Guowei, Ling Weihan. The Impact of Temperature Pressure on Borehole Fluids Density[J]. Petroleum Drilling Techniques, 2012, 40(2): 30-34. DOI: 10.3969/j.issn.1001-0890.2012.02.006
Citation: Luo Yuwei, Zhu Jianglin, Li Dong, Fang Guowei, Ling Weihan. The Impact of Temperature Pressure on Borehole Fluids Density[J]. Petroleum Drilling Techniques, 2012, 40(2): 30-34. DOI: 10.3969/j.issn.1001-0890.2012.02.006

温度和压力对井内流体密度的影响

The Impact of Temperature Pressure on Borehole Fluids Density

  • 摘要: 高温高压深井的安全压力窗口窄,井筒内不同深度之间的流体温差和压差大,且井内流体受到地层加热膨胀和液柱压力压缩造成密度变化,因而容易因入井流体初始密度选择不当造成压力失稳。利用自主研制的高温高压流体密度变化测量仪,进行了温度和压力对淡水、隔离液、水泥浆和矿物白油密度的影响试验,得到了相应的关系曲线;筛选出了适合固井水泥浆温度、压力变化的密度模型——Dodson-Standing模型;通过Drillbench软件,分别计算了入井初始密度1.2和2.0 kg/L水基钻井液和油基钻井液,在井下不同地温梯度下的当量静态密度,得到了4幅对应图版,该图版可为高温高压深井的钻井液和固井液密度设计提供参考。试验结果表明,对于井深为5 000 m、井底静态温度为270 ℃的井,入井初始密度1.2 kg/L水基钻井液的密度可降低5.58%,油基钻井液的密度可降低6.41%。

     

    Abstract: The safety pressure window is narrow in deep well with HPHT conditions,the differential pressure and differential temperature at different depth of wellbore are very huge;at the same time,the density of the fluid in the well would change when expanding due to formation heat and pressure of fluid column;therefore the improper selection of initial density of in-well fluid would lead to pressure instability.With independently developed HTHP fluid density measuring apparatus,the experiment was conducted to test the influence of temperature and pressure on fresh water,spacer fluid,water mud and mineral oil density and relevant curves were obtained;the proper density model for temperature and pressure change in well cementation was selected—Dodson-Standing Model;With Drillbench software,the water-based and oil-based drilling fluid with initial in-well density of 1.2 kg/L and 2.0 kg/L was calculated,four corresponding curves,including static equivalent density variation curve were acquired under different geo-thermal gradient.These curves could serve as reference to the density design of drilling fluid and cement slurry for deep wells under HTHP conditions.The experiment results indicated that,in the wells deeper than 5000 m with BHST higher than 270 ℃, the density of water-based fluid could be decreased by 5.58% and that of oil-based fluid decreased by 6.41%,compared with the in-well density of 1.2 g/L.

     

/

返回文章
返回